Water Resistant Windbreaker Coaches Jacket
$43.00
-
Our EXP99CNB Nylon Windbreaker Coaches Jacket is screen print friendly, and has waterproof nylon fabric with snap front closure. The Nylon exterior fabric is coated with a 100% water proof coating...however, we give this jacket a Water Resistant rating since the seams are not waterproofed, which may allow water to eventually enter through the seams or snap front closure when exposed for extended periods of time in a downpour.
Get outside and enjoy!
-
- 100% nylon 150gm 320 Denier with Interior PU waterproof coating
- Nylon Outer Shell: Waterproof Coating = Level 3
- Inner PU Coating: Breath-ability/Permeability = 5,000
- Water Pressure Resistance = 10,000 mm
- Self neck tape
- Tear away neck label
- Antique brass eyelets
- Antique brass 6 snap front closure
- Elastic cuffs
- Underarm grommets
- Drawcord closure at bottom opening
- Standard fit
-
Please Note:Use a nylon or plastisol ink with a catalyst (hardener). Certain Poly Inks can work as well. Ask your ink supplier. Keep in mind a catalyst will shorten the shelf life of the ink leaving left over ink unusable as it will harden.
Use tight screens with 200+ mesh count to lay down a little less ink than would be used on tees (tees normally use a more open mesh like a 110). Ink tends to sit on top of the surface of this fabric as opposed to pressing into cotton type fabrics. A harder squeegee can help lay down less ink and help keep cleaner design edges.
Nylon fabric also tends to move more than tees on the printing pallet. Sometimes a jacket clamp is recommended when doing multi-color prints.
Curing time and temperature will vary by ink types used on nylon fabrics. VERY IMPORTANT to cure your ink at the right temperature without burning or shrinking nylon. Nylon fabrics should usually be cured at temperatures under 320. Flash at low temperatures to keep from burning and/or shrinking fabric. (consult ink supplier and test).
Washing the printed sample garment(s) after 24+ hours (so hardener has set) is recommended to make sure you have proper curing and ink adhesion.
*ALWAYS consult your ink supplier for the right ink, cure temperatures, and curing time. Then run your own test sample(s)
